Severe Workplace Injuries in Conway, Arkansas

Oct 14, 2024 · Conway Manufacturing Group, Inc. Amputation

An employee was bending metal with machinery. As they retrieved the bent metal from the machine, the machine was activated. Their left thumb was pulled into the machine, resulting in a fingertip amputation above the knuckle.

Caught, entangled in running powered equipment normal operation · Finger or thumb tip(s), nail(s) · Manufacturing · OSHA inspection 1783478

Sep 20, 2024 · DBG Conway Amputation

An employee was operating a mechanical press machine and amputated part of the index and middle fingers on her right hand.

Caught, entangled in running powered equipment normal operation · Other finger(s) (other) · Manufacturing · OSHA inspection 1777283

Sep 3, 2024 · SFI OF ARKANSAS, LLC Amputation

An employee was polishing a shaft on a lathe when the lathe caught their glove and pulled their right hand into the lathe. The employee sustained injuries to their middle and ring fingers, as well as a partial amputation to the ring finger.

Caught, entangled in running powered equipment normal operation · Other finger(s) (other) · Manufacturing · OSHA inspection 1773600

Jun 20, 2024 · Tracy Electric Inc. Hospitalized

On June 20, 2024, at approximately 9:00 PM, an employee was descending a ladder from a cooling tower to a corner pillar. Upon reaching the corner pillar, the employee attempted to step off the pillar onto an 18-inch pipe adjacent to the cooling tower, fell onto the large pipes to the left of the 18-inch pipe. The employee was hospitalized with a partially collapsed lung and fractured ribs on their left side.

Fall, slip, trip · Multiple trunk locations · Construction

Jan 17, 2024 · Crete Carrier Corporation Hospitalized

An employee was walking to and from his semi-truck in a parking lot while looking to pick up a trailer for his next assigned load. The employee was found on the ground next to his truck after slipping on ice and falling. The employee was hospitalized with a fractured skull.

Fall on same level due to slip or trip · Skull · Transportation and warehousing

Jul 31, 2023 · Federal Bureau of Investigation Hospitalized

An employee was participating in a bomb technical training when they experienced heat exhaustion due to a heat index of 114-degrees Fahrenheit.

Exposure to environmental heat · Body systems · Administrative, staffing and waste services · OSHA inspection 1689584

Feb 7, 2023 · Sinco Inc. Hospitalized

An employee was using a brake press to bend a part. The machine cycled and came down onto both of the employee's arms, crushing them.

Caught in running equipment or machinery during regular operation · Arm(s) · Manufacturing · OSHA inspection 1650104

Nov 11, 2022 · SFI OF ARKANSAS, LLC Amputation

An employee was operating a brake press when their finger was caught in the machine, resulting in an amputation.

Caught in running equipment or machinery during regular operation · Finger(s), fingernail(s) · Manufacturing

May 10, 2022 · International Paper Company Amputation

An employee was pulling pieces of wood through a metal die rack when their left hand slipped into the rack, resulting in an amputation of their left ring fingertip.

Contact with objects and equipment · Fingertip(s) · Manufacturing

Apr 13, 2022 · Tokusen USA, Inc. Amputation

An employee was attempting to load a spool into a machine. He was trying to align the drive lugs with his left hand, working the controls with his right hand, when the machine caught his left glove. His thumb was pulled into the arbor housing. The tip of the thumb was amputated.

Caught in running equipment or machinery during regular operation · Fingertip(s) · Manufacturing · OSHA inspection 1590714

Feb 22, 2022 · DBG Arkansas, LLC. Hospitalized

The injured employee was hanging 400-pound fuel tank cages on a paint line. A co-worker was using a forklift to place a stack of parts down and began to down stack the product. When down stacking the product, the forklift bumped a lower unit and the unit fell over, striking the floor and sliding into the injured employee's left heel, resulting in a crush injury.

Struck by falling object or equipment (other) · Heel(s) · Manufacturing

Jan 4, 2022 · Tokusen USA, Inc. Amputation

An employee was checking a stranding machine that kept lighting up red, indicating an issue with the wire path. He wanted to see if the red light would come back on after he moved some wires around. He indicated he jogged the machine and the red light came on, so he moved the other detector and jogged the machine once again. He then checked the main speed reducer belt while jogging the machine. His glove caught on the belt teeth and pulled his left hand toward the pulley, resulting in a partial amputation of the third finger and a degloving of the fourth finger.

Caught in running equipment or machinery during maintenance, cleaning · Finger(s), fingernail(s) · Manufacturing · OSHA inspection 1571635

Dec 29, 2021 · HUGG AND HALL EQUIPMENT COMPANY Hospitalized

An employee was backing a telehandler onto a flatbed delivery trailer. The telehandler fell off the trailer and landed on its side on the asphalt about 3 feet below. The employee suffered a head laceration and several broken ribs, both on the right side of his body.

Ran off driving surface, nonroadway · Chest, except internal location of diseases or disorders · Wholesale trade

Dec 6, 2021 · FUREIGH ELECTRIC, INC. Amputation

Employees were installing a grate under a generator. An employee lost his grip on the grate and it grabbed his glove. His finger was pulled into the grate, which amputated the fingertip.

Contact with objects and equipment · Fingertip(s) · Construction

Sep 28, 2021 · DBG Arkansas, LLC. Amputation

As an employee was operating a brake press, their hand became caught in a pinch point, making contact with the material being bent and the upper die ram. Two of the employee's right-hand fingertips were amputated.

Caught in running equipment or machinery during regular operation · Fingertip(s) · Manufacturing · OSHA inspection 1555274

Sep 1, 2021 · Quality Roofing Contractors Hospitalized

An employee was using a hose to spread a lightweight mixture on the roof of a building when he began to suffer symptoms of heat stress, which included cramps, and was unable to move. The employee was hospitalized with heat exhaustion.

Exposure to environmental heat · Body systems · Construction

Aug 31, 2021 · ERA TEAM Real Estate Hospitalized

An employee was helping to move a desk when they tripped an fell. The employee was hospitalized for a broken pelvis.

Fall on same level due to tripping · Pelvis · Real estate and rental

May 21, 2021 · The Giving Table Amputation

A temporary employee was using the wood jointer and amputated the tip of his right pinky finger.

Caught in running equipment or machinery during regular operation · Fingertip(s) · Manufacturing

May 21, 2021 · Conway Corporation Hospitalized

An employee was on top of a ladder pulling network cable through an open ceiling to wire for a security camera. The bottom of the ladder slipped out and the employee fell close to the wall. A large piece of crown molding was sticking out from the wall and the employee hit his head on it as he fell. The employee was rendered unconscious and was hospitalized for a head injury and a laceration above the right eye.

Other fall to lower level · Brain · Manufacturing

Sep 28, 2020 · NABHOLZ CONSTRUCTION CORPORATION Hospitalized

An employee was operating a backhoe carrying a bucket full of dirt. He approached a wall and prepared to dump the dirt against it; as he was raising the bucket, the backhoe's front tire fell into a soft spot and the backhoe tipped over. The employee suffered a broken left femur.

Jack-knifed or overturned, nonroadway · Thigh(s) · Construction

Sep 8, 2020 · KIMBERLY-CLARK CORP., CONWAY MILLS Hospitalized

An employee removed the floor anchor bolts on an arbor press. While moving the press manually, it tipped over and struck the employee on the shin and ankle.

Struck by object or equipment dropped by injured worker · Ankle(s) and leg(s) (other) · Manufacturing

Jun 11, 2020 · Mid-South Sales, LLC Hospitalized

An employee was preparing to close the roll-up door on the back of a package delivery truck. He stepped backwards to place his foot on the lift gate and fell approximately 5 feet to the ground. The employee was hospitalized with a dislocated and fractured elbow that required surgery.

Other fall to lower level less than 6 feet · Elbow(s) · Wholesale trade

Apr 17, 2020 · Associated Farmers Cooperative Hospitalized

An employee was going into a warehouse when he fell, striking and injuring his head.

Fall on same level · Brain · Retail

Mar 6, 2020 · DBG Conway LLC Amputation

An employee was pressing bus parts using a 90-ton press. The machine actuated and amputated the tips of eight of the employee's fingers.

Caught in running equipment or machinery during regular operation · Fingertip(s) · Manufacturing · OSHA inspection 1468649

Sep 30, 2019 · DBG Conway LLC Amputation

An employee was building an 18-inch channel block in press brake. As he was making the second bend, his left hand went into a pinch point. The machine cycled and caused the amputation of three fingers on the left hand.

Caught in running equipment or machinery during regular operation · Finger(s), fingernail(s) (other) · Manufacturing · OSHA inspection 1437052

Aug 3, 2019 · CORESLAB STRUCTURES (ARK) INC. Amputation

An employee loaded a piece of rebar onto a rebar bending machine. His finger was in a pinch point between the end of the rebar and a positive stop on the machine when the machine was cycled, resulting in an amputation of the upper portion of his left index finger.

Caught in running equipment or machinery during regular operation · Finger(s), fingernail(s) · Manufacturing

May 30, 2018 · Virco Manufacturing Corporation Hospitalized

An employee was hospitalized for heat stress after experiencing severe cramping in his legs, arms, and abdomen.

Exposure to environmental heat · Body systems · Manufacturing · OSHA inspection 1326915

May 15, 2018 · SFI Fabrication Amputation

An employee was operating a 1,250-ton press brake to bend parts. As a part was being bent by the press dies, it swung up toward the face of the ram. The employee was still holding the part, and his right middle and ring fingertips were then pinched and amputated between the part and the front of the machine.

Caught in running equipment or machinery during regular operation · Fingertip(s) · Manufacturing

Apr 27, 2018 · Express Employment Professionals Amputation

An employee was helping a second employee feed corrugated fiberboard sheets into a slotter machine at approximately 16:15. They determined that a piece of tape was creating issues with the sheets as they fed them into the machine. The first employee was attempting to remove a piece of the tape when the machine cut his left little finger, resulting in an amputation.

Caught in running equipment or machinery during maintenance, cleaning · Finger(s), fingernail(s) · Administrative, staffing and waste services

Oct 9, 2017 · Coreslab Structures Arkansas Inc. Amputation

An employee was helping two other employees untwist metal strands from a pack when a strand quickly pulled back into the twisted position and amputated the employee's right index fingertip.

Entangled in other object or equipment · Fingertip(s) · Manufacturing